Dies were covered with four layers of die spacer, covering the en

Dies were covered with four layers of die spacer, covering the entire preparation together with the occlusal surface excluding the apical 0.5 mm

of the preparation in group 1 (40 specimens), and Ivacaftor covering the same area excluding the occlusal surface in group 2 (40 specimens). Copings were cast using nickel–chromium-based metal ceramic alloy and cemented using zinc phosphate cement. The specimens were sectioned along the long axis. Internal discrepancies were recorded with a 0.001-mm resolution stereoscope at 6 points: the middle of the occlusal surface (MO), middle of the lingual wall (ML), middle of the buccal wall (MB), middle of the buccal shoulder finish line (MSH), middle of the lingual chamfer finish line (MCH), and middle of the buccal bevel finish line (MBL). Student’s t-test was used for statistical analysis. Significance level was set at p < 0.05. The marginal discrepancies of group 1 were higher than those of group 2. Significant differences in discrepancies were found on MO (p < 0.0001), MSH (p = 0.012), and MBL (p = 0.035). The bevel margin showed the least marginal discrepancy following occlusal surface of the die with no relief. Leaving the occlusal part of the die uncovered with the die spacer improved the crown seating considerably in the occlusal surface as well as shoulder and bevel

margins. “
“Purpose: This study was undertaken to assess the influence of three-veneering materials on the marginal fit, fracture resistance, and failure pattern of In-Ceram alumina crowns. Materials and Methods: Forty In-Ceram cores were constructed www.selleckchem.com/products/Deforolimus.html and divided into four groups of ten each. Ten alumina cores were left unveneered, forming the first group for core testing, while the other MCE公司 30 copings were divided into three groups depending on the veneering material used. The vertical marginal gaps of the alumina copings were measured before and after veneer placement at 16 sites using an optical microscope. The specimens were then loaded to fracture at a crosshead

speed of 1 mm/min. Fractured specimens were examined, and the fracture patterns of the crowns were recorded. Selected specimens were examined using scanning electron microscope. Data were presented as means and standard deviation values. One-way ANOVA was used to compare between mean gap areas and fracture resistance of the three materials. Duncan’s post hoc test was used for pairwise comparison between the means when ANOVA test was significant. Results: Vitadur-N-veneered crowns showed statistically the highest mean vertical gaps, while no significant difference was evident between the marginal fits of Vitadur-α- and VM7-veneered crowns. Regarding the strength, a statistically significant decrease in fracture resistance of the cores was evident after veneering with Vitadur-N; however, no significant change in mean fracture resistance value of Vitadur-α- and VM7-veneered crowns was evident compared to the alumina cores.

Leave a Reply

Your email address will not be published. Required fields are marked *

*

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>