The structures were analyzed by CLSM and 3-D images were constructed. Architecture of

PAO1 BLS formed in the presence of 1X (A), 0.5X (B), or 2X (C) mucin. Boxes, 800.00 AG-881 supplier px W x 600.00 px H; bars, 100 px. (D) After 3 d, the gelatinous mass was removed from each well and PRIMA-1MET purchase vortexed to suspend the bacteria. The bacterial suspension was serially diluted and aliquots from each dilution were spotted on LB agar to determine the CFU/ml. Values represent the means of at least three independent experiments ± SEM. Variation in the amount of DNA produced more dramatic differences. When the amount of DNA was reduced to 0.5X (2 mg/ml), BLS were detected but confined to a small area of the gelatinous mass rather than spread throughout the medium as observed with

1X DNA (Figure 5A, B). When we increased the amount of DNA to 1.5X (6 mg/ml), individual cells were found scattered throughout the gelatinous medium, but no defined structures were detected (Figure 5C). The total biovolume, mean thickness, and total surface area of BLS developed in the presence of either 0.5X or 1.5X DNA were significantly less than those of BLS developed in the presence of 1X DNA (Tables 1 and 2). In contrast, the values of the roughness coefficient and surface to biovolume ratio were significantly increased (Table 2). This resembles the initial stage of biofilm development on an abiotic surface in which P. aeruginosa colonizes the surface and forms a single monolayer. Selleckchem 3-Methyladenine As for the variations in mucin, we enumerated the CFU/ml for PAO1 grown in ASM+ with 1X, 0.5X or 1.5X DNA, and again, comparable levels Pregnenolone of growth were obtained in each condition (Figure 5D). Figure 5 Variations in the level of DNA within ASM+ affect the development of PAO1 BLS. ASM+ containing 4 mg/ml (1X), 2 mg/ml (0.5X), or 6 mg/ml (1.5X) unsheared salmon sperm DNA was inoculated with PAO1/pMRP9-1 and incubated

for 3 d under 20% EO2/static conditions. The structures were analyzed by CLSM and 3-D images were constructed. Architecture of PAO1 BLS formed in the presence of 1X (A), 0.5X (B), or 1.5X (C) DNA. Boxes, 800.00 px W x 600.00 px H; bars, 100 px. (D) After 3 d, the gelatinous mass was removed from each well and vortexed to suspend the bacteria. The bacterial suspension was serially diluted and aliquots from each dilution were spotted on LB agar to determine the CFU/ml. Values represent the means of at least three independent experiments ± SEM. The level of EO2 affects the formation of BLS Previous studies suggested that within the lung alveoli of CF patients, P. aeruginosa survives and grows under an oxygen gradient of 10% EO2 to 0% EO2[5, 21, 22]. The experiments described above were conducted under 20% EO2. Therefore, we compared the development of the PAO1/pMRP9-1 BLS in ASM+ under 20%, 10% and 0% EO2. Cultures were incubated for 3 d under 20% and 10% EO2.