Other authors have used closely related procedures to obtain platinum, nickel hydroxide, iron, and permalloy nanostructures [39–43].

In this report we have employed AAO membranes to synthesize supported CNTs arrays without the need to use metal catalysts. Taking advantage of the protection provided by the nanotubes by the hollow alumina cylinders, we have used these CNTs as nanoreactors to grow gold nanostructures selectively inside them. The nanotubes can subsequently be extracted from the AAO template to obtain IWP-2 chemical structure hybrid peapod-like Au-CNT composites. Since our interest is evaluating the collective behavior of these hybrid nanostructures, interdigitated electrodes have been used to measure the conductance temperature dependence. Additionally, changes in the electrical resistance of these structures SAR302503 were verified under different atmospheric conditions in order to test the use of the new material as active STA-9090 ic50 elements in sensor devices.

Methods Synthesis of CNTs and Au-CNT hybrid nanostructures For the CNT synthesis, the catalytic decomposition of acetylene was carried out in a chemical vapor deposition apparatus (CVD), consisting of a horizontal tube furnace and a set of gas flow lines [44]. In a typical synthesis, performed at atmospheric pressure, a piece of alumina membrane (approximately 2 × 5 cm2) was heated at a rate of 20°C/min under an O2 stream (100 sccm) until reaching the desired synthesis temperature, (650°C). Then, O2 was replaced by Ar (100 sccm), and the system was kept under these conditions for 5 min. Acetylene (25 sccm) was later added for 10 min into the furnace. The hydrocarbon decomposes and the CNTs grow inside

the porous AAO substrate to produce at the end a CNT-AAO composite. The sample generated by this procedure was labeled as CNT_(AAO/650°C). For the Au-CNT hybrid synthesis, the CNT-AAO click here composite membranes were impregnated with a HAuCl4/2-propanol solution by dip-coating or drop-casting. Both methods were used in order to introduce quite different amounts of gold inside the CNTs. In the dip-coating procedure, a piece of membrane was completely immersed in a diluted gold solution (0.001 M) for 24 h. This sample was labeled as Au-CNT-A. To prepare a sample by drop-casting, 40 μL of a concentrated gold solution (1 M) was directly dropped on each side of approximately 1 × 1 cm2 piece of the CNT-AAO membrane. This sample was labeled as Au-CNT-B. After impregnation, the pieces of membrane were placed in a tube furnace for calcination-reduction process. First, the membranes were dried at 150°C in an Ar stream (100 sccm) for 30 min. Then an O2/Ar mixture was added into the furnace and the temperature was raised up to 350°C for 1 h. Oxygen was later replaced by hydrogen (100 sccm), and the temperature was increased again up to 450°C for 1 h. The system was then cooled down to room temperature (RT) in an Ar flow.