We confirmed that the tunnel barrier can act as an internal resistor that has variable resistance for non-linear ILRS of the device. The selectivity of the tunnel barrier internal resistor was dependent on the thermal oxidation time of the TiOx tunnel barrier. find more higher selectivity was observed in the multi-layer TiOy/TiOx than in the single-layer TiOx without thermal oxidation. TiOy can suppress electron transfer more than TiOx at VLow because of its more insulating state. Once a filament is formed in the HfO2 switching layer, the tunnel barrier dominantly is the dominant factor that controls I-V characteristics with barrier thickness modification

because RLRS is much lower than Rtunnel barrier. Therefore, it was observed that the high non-linear ILRS of the ReRAM could GNS-1480 datasheet be achieved by inserting a multi-layer tunnel barrier (Figure 2b). The non-linearity of the selector-less ReRAM was higher in the multi-layer tunnel barrier than GW-572016 manufacturer that of the single-layer tunnel barrier. Figure 2 DC I-V and non-linear behavior comparisons. (a) DC I-V comparison of multi-layer tunnel barrier (blue) and single-layer tunnel barrier (black). (b) Comparison of the non-linear behaviors of the selector-less ReRAMs by inserting multi-layer (blue) and single-layer tunnel barriers (black). Figure 3 shows the depth profile of the device and the tendency of the TiOx top surface bonding energy in relation

to the thermal oxidation time. Figure 3a shows the depth profile of the selector-less ReRAM to confirm the device structure. Every depth point was detected with an etching rate of 3 min. Total Resveratrol etch time to detect BE of Pt was 34 min. Figure 3b, c, d shows the bonding energy of the multi-layer TiOy/TiOx tunnel barrier. We focused on the top surface of the TiOx layer to confirm the thermal oxidation effect. By increasing the thermal oxidation time, we observed that the Ti4+ peak of the insulating TiOx phase increases because of thermal oxidation. In addition, the Ti2+ peak of metal Ti relatively decreases owing to thermal oxidation. Therefore, it can be seen

that the multi-layer TiOy/TiOx exhibits highly non-linear behavior owing to excellent tunnel barrier characteristics (Figure 2a,b). Figure 3 Depth profile and bonding energy change. (a) Depth profile of the selector-less ReRAM. (b, c, d) Bonding energy change in the TiOx top surface with thermal oxidation time (0-, 5-, and 10-min oxidation). Ti4+ peak increased with increasing thermal oxidation time. Second, the tunnel barrier controls filament formation during the set operation for uniform resistive switching. In general, the filament size of the ReRAM can have random fluctuation owing to the randomly distributed oxygen vacancy (Vo) of binary metal oxide switching layers and the uncontrollable current flowing during the set operation. Furthermore, a fluctuating filament reflects the large fluctuation of the reset operation, and it results in large fluctuation of HRS distributions.